Ballepresser 50 t, drev 22 kW med virbulator

Presona LP 50 EH1

Tekniske data for presse:
Manufacturer: Presona AB
Model: LP 50 EH1
Year of manufacture: 2005
Operating hours: 30,408 hours (as of April)
Number of bales pressed: 198,059 pieces (as of April)
Main press force: 50 t
Specific pressing force: 63 N/cm²
Theoretical throughput: 530 m³/h
Actual throughput under operating conditions: 260 m³/h
Feed hopper dimensions: 1,250 x 1,100 mm
Press chamber volume: 2.2 m³
Bale size: 1,100 x 720 mm, variable length
Drive power: 22 kW
Tying: 5-fold vertical, fully automatic
Throughput at bulk density of
30 kg/m³: 6 to 7 t/h
50 kg/m³: 7 to 9 t/h
100 kg/m³: 11 to 14 t/h
Bale density (paper/newspapers): 400 to 550 kg/m³
Bodpfjy R Npisx Afmswn
Hydraulic oil tank volume: 600 L
PLC control: Telemecanique TSX Micro
Operator panel: Schneider Magelis
Effective transport dimensions excluding press: 8,125 x 2,300 x 3,000 mm (L x W x H)
Transport weight press: approx. 16 t

Condition of the press:
The machine has been partially overhauled in our workshop and general maintenance work has been carried out. After completion of the overhaul, the press was tested during operation and is now available for sale at short notice.

The following overhaul work was carried out:
General work:
Machine cleaned, derusted, primed, partial repainting
Wire entry marks in the press channel feed-throughs welded and smoothed

Hydraulics unit:
Hydraulic oil tank drained, tank cleaned, new oil refilled
Oil filter and air filter replaced
Leaking oil sight glass on hydraulic tank replaced
All hydraulic hoses replaced

Electrics:
English language set in the program menu
Two key switches in the operator panel replaced
Switch cabinet replaced
Signal lamp on the control cabinet replaced
Flap limit switch replaced
Electrics of the turbulator replaced, connected and tested

Press ram:
All four guide rollers on the press ram removed and replaced
Main hydraulic cylinder dismantled, disassembled and partially overhauled, cylinder tube honed, complete seal kit replaced, leakage test carried out
All plastic wear pads on the press ram replaced

Pre-press flap:
Both bearings on the pre-press shaft replaced
Both hydraulic cylinders dismantled, disassembled and partially overhauled, both cylinder tubes honed, complete seal kits replaced, leakage test carried out
Scraper flap on the pre-press replaced

Tying unit:
Two complete needles with wire guide rollers replaced
Needles readjusted and set
All wire guide rollers in the needle heads replaced
Twister finger replaced
Two twister shafts replaced
All 8 wear plates on the twisting unit, under the twister fingers, replaced

Scope of delivery:
Only the baler is for sale.
Documentation (operating manual, CE declaration, electrical/hydraulic schematic) is complete. Inspection is possible by appointment. We assume no liability for technical specifications or possible errors.

Annoncen er blevet oversat automatisk. Oversættelsesfejl kan forekomme.